Port Security Commands - D-Link xStack DGS-3426 Cli Manual

The Switch's port security commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
config port_security ports
delete port_security entry
clear port_security_entry
show port_security
Each command is listed, in detail, in the following sections.
config port_security ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the port security:
xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Parameters
[<portlist> | all] {admin_state [enable| disable] | max_learning_addr
<max_lock_no 0-16> | lock_address_mode [Permanent |
DeleteOnTimeout | DeleteOnReset]}
vlan name <vlan_name 32> port <port> mac_address <macaddr>
port <portlist>
{ports <portlist>}
Used to configure port security settings.
config port_security ports [<portlist> | all] {admin_state [enable|
disable] | max_learning_addr <max_lock_no 0-16> |
lock_address_mode [Permanent | DeleteOnTimeout |
DeleteOnReset]}
This command allows for the configuration of the port security feature.
Only the ports listed in the <portlist> are affected.
portlist − Specifies a port or range of ports to be configured.
all − Configure port security for all ports on the Switch.
admin_state [enable | disable] – Enable or disable port security for the
listed ports.
max_learning_addr <max_lock_no 0-16> - Use this to limit the number of
MAC addresses dynamically listed in the FDB for the ports.
lock_address_mode [Permanent | DeleteOnTimout | DeleteOnReset] –
Indicates the method of locking addresses. The user has three choices:
Permanent – The locked addresses will not age out after the
aging timer expires.
DeleteOnTimeout – The locked addresses will age out after the
aging timer expires.
DeleteOnReset – The locked addresses will not age out until the
Switch has been reset.
Only administrator-level users can issue this command.
DGS-3400:4#config port_security ports 1-5 admin_state enable
max_learning_addr 5 lock_address_mode DeleteOnReset
Command: config port_security ports 1-5 admin_state enable
max_learning_addr 5 lock_address_mode DeleteOnReset
Success.
DGS-3400:4#
P S
ORT ECURITY
24
6
C
OMMANDS