Audio-Conferencing - Revolabs Fusion Setup Manual

Set-Up Guide
STEP 2: Audio Conferencing
Plug Cable A (single RCA to double RCA) single RCA connector into Fusion Base Station
<Room Out> RCA port, and then plug the double RCA connectors into the powered
speakers or a powered amplifier. Plug speakers into wall outlet.
Plug one end of Cable B, the phone line cable, into the Fusion Base Station <Line In>,
plug other end into phone jack. You may also plug a phone into the RJ11 <Set In>, You
may then dial with the remote control or the phone.
If you ordered 01-8FUSION(EU)-62 6 omni tabletops/2 wearable microphones or 01-
4FUSION(EU)-31 3 omni tabletops/1 wearable microphone. You are all set to go! Take
out the Wireless Microphones, unmute them by pressing the mute button on the
microphone and the system is ready for a conference!
If you selected your microphones separately with the 01-8FUSION(EU)-NM or 01-
4FUSION(EU)-NM Fusion part numbers, you must first establish a connection between
your microphones to the Fusion Base Station. This is called "pairing". Refer to page 9.
STEP 2: Video Conferencing
You must have the audio output going from the Fusion Base station directly to the speakers
used by the video-conferencing station. Plug Cable A (single RCA to double RCA) single
RCA connector into Fusion Base Station <Room Out> RCA port and then plug the double
RCA connectors into the speakers or monitor.
Once you have configured your video-conferencing station as shown on pages 11-17, then:
If you ordered 01-8FUSION-62 6 omni tabletops/2 wearable microphones or 01-
4FUSION-31 3 omni tabletops/1 wearable microphone. You are all set to go! Take out
the Wireless Microphones, unmute them by pressing the mute button on the microphone
and the system is ready for a conference!
If you selected your microphones separately with the 01-8FUSION-NM or 01-4FUSION-
NM Fusion part numbers, you must first establish a connection between your microphones
to the Fusion Base Station. This is called "pairing". Refer to page 9.
Page 8