Print Mode Tear Off Peel Off Cutter; Print Width - LabelStation Pro 240 User Manual

Press to enter the value. Press MENU to cancel the setting and return to the
SELECT
previous menu. The default value is +000
Note: These settings, made at the printer, will be over-written by commands from the labelling
software (label template) at print time unless the "Use current printer settings" option is used
in the labelling software.
3.1.2.4 Print Mode: (Tear Off / Peel Off / Cutter)
Print Setup
Print Speed
Tear-off
> Print Mode
This option is used to set the print mode. The default setting is 'Tear Off'. Press
keys to select the required print mode and press
DOWN
Press MENU key to cancel the setting and return to the previous menu.
Printer Mode
Note: These settings, made at the printer, will be over-written by commands from the labelling
software (label template) at print time unless the "Use current printer settings" option is used
in the labelling software.

3.1.2.5 Print Width:

Print Setup
Tear-off
Print Mode
> Print Width
This option is used to set print width. Press the
digit to right digit, and press the
Press the SELECT key to enter the setting. Press MENU key to cancel the setting and
return to the previous menu.
Note: These settings, made at the printer, will be over-written by commands from the labelling
software (label template) at print time unless the "Use current printer settings" option is used
in the labelling software.
LabelStation Pro 240
4/17
Tear off
Peel off
Cutter
5/17
UP
Print Mode
> Tear off
Peel off
Cutter
Enable the Peel-off module (if fitted)
Enable the electric cutter (if fitted)
Print Width
812 dot
DOWN
to set the value from "0" to "9" or "dot" to "mm".
key
Page 32 of 67
1/4
key to enable the setting.
SELECT
Description
Enable the Tear-off mode
key to move the cursor from left
and
UP