Table of Contents
Advertisement
1
4. Place the roll of label on the label supply spindle. Flip up the label roll guard.
Note:
When inserting the 3 inch core adapter to the spindle, please make sure the arrow direction is as
shown below. When using a 1 inch core label, please remove the 3 inch core adaptor from the label
supply spindle.
3 inch label core
LabelStation Pro 240
Print-head carriage
3
Label roll guard
2. Push the print-head release lever (in direction
indicated) to open the print-head carriage.
3. Move the label roll guard horizontally to the
2
end of label spindle then flip it down.
Page 17 of 67
1 inch label core
Advertisement
Table of Contents
