Loading Media In Peel-Off Mode (Option) - LabelStation CN User Manual

4. Press down the media holder lock switch to fix the media holder.
5. Feed the media through the rear external label entrance chute. Place the paper, printing side face
up, through the media sensor and place the label leading edge onto the platen roller.
6. Move the media guides to fit the label width by turning the guide adjuster knob.
7. Disengage the top cover support and close the top cover gently.
8. Use the "Diagnostic Tool" or your labelling software to select and calibrate the appropriate media
sensor for your label type.
(If you use the "Diagnostic tool" click as follows: Select the "Printer Configuration" tab then click the
"Calibrate Sensor" button ).
Always be prepared to recalibrate the gap/black mark sensor after changing the media (label stock)

3.4.3 Loading Media in Peel-off Mode (Option)

1. Refer to previous instructions to load the media.
16