Print Config; Dump Mode; Rotate Cutter - LabelStation Pro 240 User Manual

3.3.1 Print Config.

This feature is used to print out all the current configuration settings onto a label, including a test
pattern to obviate any defective dot/pixels in the print-head (failed heater elements). Please refer to
section 4.2.
Diagnostics
> Print Config.

Dump Mode

Rotate Cutter

3.3.2 Dump Mode
Captures data from the communications port (data received by the printer) and prints it out. In dump
mode, all information is printed in two columns, the left column being characters received from your
system and the right column being their corresponding hexadecimal values. This allows users and
engineers to verify data and debug the program. Please refer to section 4.2.
Diagnostics
Print Config.
> Dump Mode
Rotate Cutter
Notes:
1. Dump mode requires 4" (100mm) wide paper width.
2. To resume normal printing, turn the printer off briefly.
3. Press the FEED button to return to the previous menu.
3.3.3 Rotate Cutter
This feature can be used to rotate the cutter blade forward or reverse to assist in the removal of
jammed label.
Diagnostics
Print Config.
Dump Mode
> Rotate Cutter
LabelStation Pro 240
1/4
Self Test ...
2/4
Printing ...
3/4
UP:
DOWN:
MENU:
1/1
Fwd.
Rev.
Exit
Page 51 of 67
Printing ...
1/1
Dump Mode