Table of Contents
Advertisement
The SD Card is
The SD Card
inoperable.
is damaged or
not inserted
correctly. The
card is not of
an approved
type.
Ribbon and/or
Poor print
media loaded
quality.
incorrectly.
Dust or
adhesive has
accumulated
on the print-
head.
Print density
and speed not
optimised.
Print-head has
damaged
elements.
Ribbon and
media are
incompatible.
The print-head
pressure is not
adjusted for
best results.
Printer
LCD unlit but
initialisation
LEDs
unsuccessful.
illuminated.
LCD cable
LCD unlit, LEDs
connector
illuminated,
loose or
label issuing
plugged in
from the printer.
upside down.
Cutter
Cutter not
connector
working.
loose
Label guide
Label drifting
not adjusted to
sideways
edge of label.
causing
misaligned
print.
LabelStation Pro 240
Check the card is inserted correctly and/or try it in another device.
Check the card's specification.
* Reload the supply.
* Clean the print-head.
* Clean the platen roller.
* Adjust the print density and print speed.
* Run printer self-test and check the print head test pattern if there is
dot missing in the pattern.
* Change proper ribbon or proper label media.
* Adjust the print-head pressure adjustment knob.
- If the left side printout is too light, please adjust the left side
pressure adjustment knob to the higher index (higher pressure). If the
pressure adjustment knob has been adjust to index "5" and the poor
print quality is still at the left side of the printout, pressure adjustment
knob to index "1" and use the Z-axis adjustment knob to fine tune the
pressure.
- If the right side printout is too light, please adjust the right side
pressure adjustment knob to the higher index (higher pressure) If the
pressure adjustment knob has been adjust to index "5" and the poor
print quality is still at the right side of the printout, pressure
adjustment knob to index "1" and use the Z-axis adjustment knob to
fine tune the pressure.
* The release lever does not latch the print-head properly.
Re-initialise the printer. Switch printer off briefly.
Connect the cable correctly.
Connect the cable correctly.
Adjust position of label guide until label cannot be moved sideways.
Page 61 of 67
Advertisement
Table of Contents
