Table of Contents
Advertisement
2. Refer to chapter 2.6.1 to install the label.
3. Use the DiagTool to set the label sensor type and calibrate the appropriate sensor.
Refer to chapter 4.
4. Pull the label through the front of the printer and remove some labels to expose the
bare liner.
5. Feed the bare liner through the peel-off unit.
After changing label roll it may be necessary to calibrate the gap/black mark sensor.
6. Close the peel-off unit cover and print-head carriage.
LabelStation Pro 240
Liner
Label
Liner
Slot
Page 20 of 67
Label
Advertisement
Table of Contents
