LabelStation Pro 240 User Manual page 41

Entering the Manual option displays the following message, with steps which must be completed:
Mode
Paper Len.
00151 dot
BLine Size
0024 dot
BLine Mode
Scan Mark
Intensity
Ref. Level
BLine Mode
Scan Paper
Intensity
Ref. Level
LabelStation Pro 240
Actions
1. Press the
to right digit, and press the
"0" to "9" and the "dot/ mm/ inch". Press the
set the paper length.
2. Press the
to right digit, and press the
"0" to "9" and the "dot/ mm/ inch". Press the button to set the
bline size into the printer.
The width of the line in dots can be calculated as follows:
200 dpi printer: Width of line in mm x 7.87
300 dpi printer: Width of line in mm x 11.81
3. Open the print-head mechanism, manipulate the label to
position the black mark centrally under the label sensor, then
close the print-head mechanism. Press the SELECT key to
scan the label and capture the value.
X
XXX
Label Sensor
Black Line under sensor
4. Open the print-head mechanism, manipulate the label to
position a blank area (no black mark) under the label sensor,
then close the print-head mechanism. Press the SELECT
key to scan the label and capture the value.
X
XXX
Page 41 of 67
DOWN key
to move the cursor from left digit
key
UP
DOWN key
to move the cursor from left digit
key
UP
to set the value from
SELECT key
to
to set the value from