Table of Contents
Advertisement
Label sensor bar
LabelStation Pro 240
Label supply spindle
Label guide bar
Label sensor
location
horizontally adjustable
Label guide
Page 18 of 67
5. Pull label roll leading edge forward through the
label guide bar, label sensor and place the label
leading edge onto the platen roller.
6. Adjust the label guide to fit the width of the
label. The label sensor actually comprises two
sensors - a gap sensor and a facing black line
sensor.
Make sure the label sensor (indicated
by the triangle) traverses the label's gaps,
black lines or punched holes as appropriate.
This is important.
7. Close the print-head carriage, making sure the
latches are engaged securely.
8. Calibration of the gap/black mark sensor is
sometimes necessary after changing label roll. To do
this, use the DiagTool (supplied on the CD) referring
to section 4
Advertisement
Table of Contents
