Table of Contents
Advertisement
Function
Calibrate Sensor
Ethernet Setup
RTC Setup
Print Test Page
Reset Printer
Factory Default
Dump Text
Ignore AUTO.BAS
Configuration Page
Password Setup
Note:
For more information about the Diagnostic Tool, please refer to the diagnostic utility quick start
guide on the CD that came with your printer.
The factory default settings are listed as below.
Parameter
Speed
Density
Label width
Label height
Sensor type
Gap setting
Print direction
Reference point
Offset
Print mode
Serial port settings
Code page
Country code
Clear flash memory
Shift X
Shift Y
Gap sensor
sensitivity
Bline sensor sensitivity
Language
IP address
LabelStation Pro 240
Description
Calibrate the sensor specified in the Printer Setup group
media sensor field
Setup the IP address subnet mask gateway for the on board
Ethernet (Please refer to next section)
Synchronize printer Real Time Clock with PC
Print a test page
Reboot printer
Initialize the printer and restore the settings to factory default
To activate the printer dump mode.
Ignore the downloaded AUTO.BAS program
Print printer configuration details
Set a password to protect the settings
Default setting
5 inches/sec. (127 mm/sec)
8
4.00" (101.6 mm)
4.00" (101.6 mm)
Gap sensor
0.12" (3.0 mm)
0
0,0 (upper left corner)
0
Batch mode
9600 bps, none parity, 8 data bits, 1
stop bit
850
001
No
0
0
3 (Sensor will need recalibrating)
2 (Sensor will need recalibrating)
English
DHCP
Page 54 of 67
Advertisement
Table of Contents
