Table of Contents
Advertisement
2.6.2 Loading Fan-fold Label
Fan-fold label feeds through an aperture in the rear of the printer. For the initial three steps, see
previous illustrations.
1. Open the printer right side cover.
2. Push the print-head release lever to open the print-head carriage.
3.
Move the label roll guard horizontally to the end of label spindle then flip it down (horizontal).
5. Insert the fan-fold label through the rear aperture of the printer.
6. Pull the fan-fold label leading edge forward through the label guide bar, label sensor and leave
it resting on the platen roller.
7. Adjust the label roll guard and label guide by sliding them to up to the edge of the label.
8. Close the print-head carriage, making sure the latches are engaged securely.
9. Calibrate the printer to the appropriate sensor,
e.g. Gap, Black Mark or Continuous. Refer to
section 4 for more information.
2.6.3 Loading the Label in Peel-off Mode (the peeler is an optional extra)
1. Open the peel-off unit by releasing the catches and pulling it down.
LabelStation Pro 240
4. Remove the 3 inch core adapters from the
label supply spindle.
Note: This operation is often necessary when
changing the label roll.
Page 19 of 67
Advertisement
Table of Contents
