Loading Labels With The Cutter Unit Attached (Optional) - LabelStation Pro200 series User Manual

2.3.2.

Loading Labels with the Cutter Unit Attached (Optional)

• Insert the label spindle into your label roll (as section 2.3.)
• Open the printer top.
• Install the label roll on the paper roll mount.
• Feed the labels, printing side face up, through the paper guide and pass over the
platen.
• Lead the labels through the cutter paper opening.
•
Adjust the paper guides by moving left or right to fit the labels width.
Paper Guide
Cutter
• Close the top cover by lifting up the top cover support and close the top cover slowly
Fig.13. Label installation in cutter mode
Fig.14. Complete label installation in cutter mode
- 13 -
© Advanced Labelling Limited July 2008
Top Cover
Top Cover
Support
Platen
LabelStation Pro Series Set Up Manual July 2008