Loading The Label In Cutter Mode (The Cutter Is An Optional Extra) - LabelStation Pro 240 User Manual

LabelStation Pro 240
Liner
7. Use the DiagTool (or labelling software) to set the printer to Peeler Mode. Refer to chapter 4.
Peeling will now take place when a label is printed. Press the FEED button to test it.
Printed label exits here
Spent liner exits here

2.6.4 Loading the label in Cutter Mode (the cutter is an optional extra)

1. Install the label. Refer to chapter 2.6.1.
2. Lead the label through the cutter entry slot.
3. Adjust the label guide to the edge of the label.
Cutter entry slot
Page 21 of 67