Table of Contents
Advertisement
3.1.1.1 Speed:
Print Setup
>
Speed
Density
Direction
Use this option to setup print speed. Each increment/decrement is 1 ips. Printer default density is 5
ips (203 dpi) or 3 ips(300 dpi).
Press UP
key to raise the print speed, and press DOWN
Press SELECT key to set it into printer. Press MENU key to cancel the setting and return to the
previous menu.
Note: These settings, made at the printer, will be over-written by commands from the labelling
software (label template) at print time unless the "Use current printer settings" option is used
in the labelling software.
3.1.1.2 Density:
Print Setup
Speed
>
Density
Direction
Use this option to setup printing darkness. The available setting is from 0 to 15 levels, and the
increment is 1 level. Printer default density is 8.You may need to adjust your density based on
selected media/ribbon.
Press UP
and DOWN
enable the setting. Press MENU key to cancel the setting and return to the previous menu.
Note: These settings, made at the printer, will be over-written by commands from the labelling
software (label template) at print time unless the "Use current printer settings" option is used
in the labelling software.
3.1.1.3 Direction:
Print Setup
Speed
Density
>
Direction
LabelStation Pro 240
1/12
2/12
keys to increase/decrease the printing darkness. Press SELECT key to
3/12
Page 26 of 67
Speed
6
key to decrease print speed.
Density
8
Direction
0
Advertisement
Table of Contents
