Installation Method When The Got Is Turned On - Mitsubishi GT10 User Manual

17.3 Standard Monitor OS/Communication
Driver Installation Using Memory Board
The memory board can be used only for GT104 , GT105 .
There are the following two types for the standard monitor OS, communication driver installation using
memory board.

(1) Installation method when the GOT is turned on

For 2-point press: When the GOT is turned on, all the OS and project data stored in the memory
For 1-point press: Use this method to transfer the OS and project data stored in the memory board
(2) Installation using GT10-50FMB function (utility)
Select OS or project data stored in the memory board, and then transfer it to the GOT using the
utility function.
For details of GT10-50FMB function, refer to the following.
Section 14.5 GT10-50FMB
17.3.1 Installation method when the GOT is turned on
1 Operation procedure
• For 2-point press
17.3 Standard Monitor OS/Communication Driver Installation Using Memory Board
board are transferred to the GOT.
to the GOT after selecting the copy direction and copy target when the GOT is
powered ON.
17.3.1 Installation method when the GOT is turned on
1 Power OFF the GOT, and attach the memory
board which stores the standard OS and
communication driver to the GOT.
2 While touching the upper left corner and lower
left corner of the GOT screen, power ON the
GOT.
3 The screen on the left is displayed.
Touch the [OK] button to start the installation,
and [CANCEL] for the cancellation.
17
18
17 - 3