Installing When Starting The Got - Mitsubishi GT16 User Manual

7.3.1

Installing when starting the GOT

The displayed message is different depending on the installation condition of standard monitor OS. When the screen
requesting operation is displayed, operate the GOT according to the instructions on the screen.
POINT POINT POINT
(1) Drives to be used
When installing OS at power-on, use the A or E drive.
The B drive cannot be used for OS installation at power-on.
(2) S.MODE switch-pressing installation function
When the CF card or USB memory that stores data with the OS boot drive set to the A drive is used, the
S.MODE switch-pressing installation function is not available.

Operation procedure
The S.MODE switch is on the back of the GOT, as shown below.
(1) When installing with CF card
1.
Power OFF the GOT, switch the CF card access switch to OFF, and install the CF card where the BootOS,
standard monitor OS or project data is stored in the CF card interface of the GOT.
2.
Switch ON the CF card access switch of GOT.
3.
Power on the GOT.
Power on the GOT while pressing the install switch (S.MODE switch) on the back of the GOT. (1-point
press installation function)
4.
The BootOS or standard monitor OS is installed in the built-in flash memory.
The CF card access LED is lit during the install execution.
Do not pull out the CF card or power off the GOT while the CF card access LED is lit.
7.3 BootOS and Standard Monitor OS Installation Using CF Card or USB Memory
Installation switch
(S.MODE)
Now installing BootOS.
1
2
3
4
5
6
7
7 - 5