Replacing The Splash Guard - Invacare Bora XTR Series Service Manual

® ®
Invacare - Bora /Spectra
7.16

Replacing the splash guard

ATTENTION: Danger of crushing to the hands and feet by the weight of the wheelchair!
· Pay attention to the hand and feet.
· Use proper lifting techniques.
Injury hazard caused by uncontrolled movement of the mobility device!
· Switch the power supply off (ON/OFF key).
· Engage the drive.
· Before raising the vehicle, secure the wheels by blocking them with wedges.
· Prevent the mobility device tipping by propping it up on a wooden block which is long and wide
enough under the battery case! If the wooden block is too short or too high, the mobility device
can still tip!
Requirements:
· 5 mm Allen key
· Mounting kit
· wooden block (approx.12 x 12x 30 cm) for propping up vehicle
Note
If the splash guard is replaced, the existing motor bracket screws are reused. Ensure that the
screws are inserted in the correct position.
· Remove legrests.
· Release seat (1) and tilt forwards.
· Disconnect the remote bus cable from the
electronics module or ACT.
· Lift the seat out of the front anchorage and
remove it. The seat has a heavy weight. Use
proper lifting techniques.
· Remove both battery cases as described in
Chapter 7.7.1.
· Undo and remove the four screws (1) & (2) on
the motor bracket which hold the splash guard
(4) using a 5 mm Allen key.
· Remove the reinforcing plate (3).
· Remove and replace the splash guard.
®
XTR Series SERVICE MANUAL
93