Seat System Modulite; Replacing The Tilt Actuator - Invacare Bora XTR Series Service Manual

SERVICE MANUAL
7.19

Seat system Modulite

7.19.1 Replacing the tilt actuator

Note
Replacing the actuator for the seat angle adjustment in the lifter / seat tilt adjustment module is
also described.
Requirements:
· Screwdriver, flat, width 6 mm
· 13 mm jaw spanner (2x)
· Slotted screwdriver
·
Remove legrests.
·
Switch the electronics OFF on the remote.
·
Disconnect the actuator cable from the cable
harness
Variant actuator - tilt:
·
Bottom fixing bolt (3) with nut (4) –
Loose the nut with the open-ended wrenches.
Remove the nut and bolt.
·
Top fixing bolt (2) secured with snap rings (1) –
Remove a snap ring using a screwdriver and
remove the bolt.
·
Pull the actuator out.
·
Insert a new actuator.
·
Reassembly takes place in the reverse order.
·
Connect the actuator cable to the cable harness.
·
To complete, check all seat tilting function
Variant seat angle adjustment actuator in the
lifter/seat angle adjustment module:
·
Bottom fixing bolt (3) with slot –
Loosen the fixing bolt with a screwdriver.
Remove the bolt.
·
Top fixing bolt (2) secured with snap rings (1) –
Remove a snap ring using a screwdriver and
remove the bolt.
·
Pull the actuator out.
·
Insert a new actuator.
·
Reassembly takes place in the reverse order.
·
Connect the actuator cable to the cable harness.
·
To complete, check all seat tilting function.
102
® ®
Invacare - Bora /Spectra
®
XTR Series