Adjusting Toe In And Out; Replacing Camber Inserts - Invacare Top End Eliminator User Manual

8.2 Adjusting Toe in and Out

1. Loosen, but do not remove the socket screws A and
clamps B that secure camber inserts C to the camber
bar D.
2. Slowly rotate each camber insert equally until the rear
wheels are approximately in a straight line.
3. Securely tighten the socket screws and clamps that
secure the camber inserts to the camber bar.
4. Measure the distance between the center lines at the
rear and front of the rear wheels at approximately 12
inches from the ground/floor.
5. Repeat STEPS 1-4 until the toe in/toe out measurement
is less than 1/8-inch (for maximum rollability).
60001470-A
Fig. 8-2

8.3 Replacing Camber Inserts

1. Loosen, but do not remove the socket screws A and
clamps B that secure camber inserts C to the camber
bar D.
2. Remove the existing camber insert from the camber bar.
3. Install the new camber insert into the camber bar.
4. Adjust the toe in/toe out of the racing chair.
Fig. 8-3
Wheels
39