Anti-Tipping Mechanism; Replacing The Anti-Tipping Mechanism With Screw - Invacare Bora XTR Series Service Manual

® ®
Invacare - Bora /Spectra
7.12

Anti-tipping mechanism

7.12.1 Replacing the anti-tipping mechanism with screw

CAUTION!
Danger of tipping over if the anti-tipping mechanism is incorrectly installed.
· Always install the anti-tipping mechanism in the first drill hole (long adjustment) on a
wheelchair with a lifter.
Requirements:
· 10 mm socket wrenches (two of them)
· Loosen and remove the self-securing nut (3).
· Remove screw.
· Pull the anti-tipping mechanism (1) rearward
out of the support tube (2).
· Insert the anti-tipping mechanism into the
support tube.
- Wheelchair with a lifter:
first drill hole (long adjustment)
- Wheelchair without a lifter:
second drill hole (short adjustment)
· Insert screw.
· Re-position the self-securing nut and tighten.
®
XTR Series SERVICE MANUAL
81