Advertisement
1. Loosen the cable brake adjuster unit locknut.
2. Do one (1) of the following:
• To increase tension, turn the cable adjuster unit counterclockwise.
• To decrease tension, turn the cable adjuster unit clockwise.
3. Retighten the cable adjuster unit locknut.
4. Test the brake. If the tension of the brake handle is still too loose/tight, repeat
STEPS 1-3.
FIGURE 10 Adjusting the Cable Adjuster Unit - Cable Assembly - Model 65420
Replacing Seat - Model 65420 Only
1. Refer to Opening/Folding Rollator on page 2 of this instruction sheet.
2. Place on the floor with the back of the seat facing up.
3. Remove the four (4) screws,
washers and two (2) spacers that
secure the seat to the frame.
4. Remove the four (4) screws and two
(2) brackets that secure the seat to
the frame.
5. Remove the existing seat.
6. Install new seat onto frame using
new hardware. See FIGURE 11 for
proper orientation. Tighten
hardware against seat until snug.
Replacing Tires
1. Remove the cap covers from both sides of the tire.
2. Remove the screw and locknut that
secure the tire to the rollator.
3. Remove existing tire.
4. Install new tire and secure with new
screw and new locknut.
5. Install new cap covers.
Part No 1076166
Cable
Top of Rear Leg
7
Brake Handle
Cable Adjuster
Unit Locknut
Cable Adjuster Unit
Spacer
Washers
Screws
Bracket
Screws
FIGURE 11 Replacing Seat - Model
65420 Only
Cap Cover
Screw
FIGURE 12 Replacing Tires
Spartan and Sprint Rollators
Seat
Frame
Tire
Locknut
Cap
Cover
Advertisement
