Replacing The Drive Wheel Hub (Ssd Motor) - Invacare Bora XTR Series Service Manual

® ®
Invacare - Bora /Spectra
7.2.9

Replacing the drive wheel hub (SSD motor)

CAUTION!
Possible material damage to mobility device! Collisions can be caused if the adjusting
washers are removed during fitting work to the drive wheels!
· Adjusting washers are often fitted between the drive shaft and the wheel hub to even out
tolerances. If these adjusting washers are removed and not replaced again, collisions can be
caused.
· Always replace the adjusting washers exactly as they were before you started dismantling.
Requirements:
· Torque wrench with 19 mm socket spanner
· Blade screwdriver
· Mounting kit
Uninstalling a drive wheel hub:
· Remove the hub cover with the screwdriver
· Use the 19 mm socket wrench to loosen and remove the nuts (7).
· Remove the washer (6).
· Remove the distance ring (5).
· Pull the wheel hub (4) off of the axle (2).
· Remove the shim ring (3).
· Remove the feather key (1) from the axle.
®
XTR Series SERVICE MANUAL
51