Fitting The Clutch Rotary Knob (Ssd Motor) - Invacare Bora XTR Series Service Manual

® ®
Invacare - Bora /Spectra

7.2.10 Fitting the clutch rotary knob (SSD motor)

Note
When replacing the clutch rotary knob, you must ensure that the correct fitting position is used
during assembly.
Requirements:
· 3 mm Allen key
· Screw the shim on to the grub screw.
· Place the screw joint in the rotary knob
(rear side (1)).
· Check to ensure that the screw joint (4) is
positioned precisely in the rotary knob.
· Place the nonwoven fabric (3) in the
rotary knob (rear side (1)).
· When installing the rotary knob (5) ensure that
the position (6) is correct.
· Tighten the bolt using a 3 mm Allen key.
· Checked to ensure that the clutch rotary knob
can be turned to the "push" position (clockwise)
and "drive" position (counterclockwise).
®
XTR Series SERVICE MANUAL
53