Installing Accessories; Replacing The Holding Strap; Standard Seat & Flex2 - Invacare Bora XTR Series Service Manual

SERVICE MANUAL
8

Installing accessories

8.1

Replacing the holding strap

8.1.1 Standard seat & Flex2
Requirements:
· open-ended spanner, 13 mm
· 5 mm Allen key
Note
A nut is fixed between the two washers (2) and (4) as a spacer so that the belt mounting can
rotate freely.
· Remove the plastic cap (5).
· Loosen the bolt (3) and the associated nut (in
the figure this is covered by the plastic cap)
with a 5 mm Allen key and a 13 mm socket
spanner.
· Remove the nut.
· Remove the bolt including safety belt and flat
washers (2) and (4).
· Remove the flat washers (4).
· Replace the safety belt (1).
· Refit the parts in the reverse order.
118
® ®
Invacare - Bora /Spectra
®
XTR Series