Backrest Unit; Replacing The Standard Backrest - Invacare Bora XTR Series Service Manual

SERVICE MANUAL
7.18

Backrest unit

7.18.1 Replacing the standard backrest

Requirements:
· 5 mm Allen key
· open-ended spanner, 10 mm
· open-ended spanner, 13 mm
Dismantling the backrest unit:
· Remove the backrest cushion.
· Undo and remove the handwheels (3).
· Use two 13 mm socket spanners to undo the bolts (4) including the nuts and washers on the
left-hand and right-hand side of the chair.
· Remove the backrest tube (1) from the backrest holders (2).
· If the backrest holders also need to be replaced: Undo and remove the Allen screws (5)
including the nuts and washers on the left-hand and right-hand side of the chair. To do this, use
a 5 mm Allen key and a 10 mm socket spanner.
100
® ®
Invacare - Bora /Spectra
®
XTR Series