SERVICE MANUAL
7.19.5 Replacing the backrest actuator
Requirements:
· 8 mm Allen key
· open-ended spanner, 10 mm
· open-ended spanner, 13 mm
Dismantling the backrest actuator:
·
Pull the cable off directly where it is connected to the actuator (2).
·
Detach the bracket of the actuator at the top and bottom; to do this, slide the bolts (4) to the
side using the lever (5) and tilt the actuator (2) out of the backrest clamp (3).
·
Replace actuator.
Note
To increase the angle of the backrest, you can remove the adapter (1). See chapter 7.19.6.
Refitting the backrest actuator:
· Assemble the parts in the reverse order.
108
®
®
Invacare
- Bora
/Spectra
®
XTR Series