®
®
Invacare
- Bora
/Spectra
7.17
Seat system
7.17.1 Checking an adjusting motor
Requirements:
· Multimeter
· Remove legrests.
· Release seat (1) and tilt forwards.
· Remove the adjusting motor plug from the
electronics module or ACT (see Chapter 4.2).
· Check the electrical resistances at the
adjusting motor plug (1).
The plug may have a different shape to that
shown in the picture.
· If the resistance is close to infinity, the motor
is probably burnt out.
· If the resistance is below 1 W, the motor has
a short-circuit.
· The motor must be replaced in both cases.
®
XTR Series
SERVICE MANUAL
95