Flex2 Seat - Invacare Bora XTR Series Service Manual

SERVICE MANUAL
9.2.2

Flex2 seat

Requirements:
· 4 mm Allen wrench
· 5 mm Allen wrench
· 13 mm open-ended wrench
· Flat screwdriver
· Smal hammer
WARNING: Danger of crushing!
The seat is very heavy. Danger of injury to hands and feet!
· Pay attention to the hand and feet.
· Use proper lifting techniques.
The illustration shows the Flex2 seat from above
without seat covering.
·
Loosen the fixation screws at the
appropriate positions (2).
·
Slide the Flex2 seat forward or rearward
until the fixation screws can be inserted into
the corresponding variation holes:
1 – Rear
2 – Middle
3 – Front
·
Replace the fixation screws and tighten.
·
Re-install all seat components.
·
Check all functions during a test-drive.
132
® ®
Invacare - Bora /Spectra
®
XTR Series