Sv8100 Programming; Programming The Sv8100 Using A Script - NEC Univerge SV8100 Installation Manual

SV8100 Programming

MyCalls requires two TCP connections to the SV8100 in order to work, SMDR and P Command.
SMDR is used to provide call information after calls has completed. P Commands are used to display
real time information such as extension status and calls in queue information. The output can be
either collected from the Ethernet port on the CCPU or from an IPLA port if one is installed, the
programming sequence on the SV8100 is the same regardless of which port the data is gathered
from.
There are two ways in which the SV8100 can be programmed, using a script or setting the commands
manually. Using a script will program the PBX in a matter of seconds, setting the command manually
through the PC Programming tool.
Where Netlink is being used all of the SMDR and P Commands are all output from the Primary
system.

Programming the SV8100 using a Script

The script will enable all programmed extensions and trunks for SMDR output. The SMDR
configuration will also be changed for MyCalls preferred output. The TCP Ports for SMDR and P
Commands will be set to 4001 and 4000. A full list of commands are shown in the Programming the
SV8100 Manually section of this manual.
Connect to PC Pro and download the configuration from the SV8100. Once the configuration has
downloaded, select Scripts from the Tools menu.
Click the yellow folder in the box next to open the script file