Locating The Call Recording Unit And Pc; Installing The Call Recording Software - NEC Univerge SV8100 Installation Manual

Once the NTE has been connected to the BRI or PRI in socket, the 'In' status led should change to
amber. When the cable between the BRI or PRI out has been connected to the ISDN card in the
PBX, you should see a layer one light on the ISDN card in the PBX. The 'Out' status light will also
show amber when the out is connected to the ISDN card in the PBX.
If the power is disconnected from the recording unit, all calls that are in progress will be disconnected.
Any new calls that pass through the box will continue to be connected whilst the call recording unit
does not have any power. When the unit is powered down, no calls can be recorded. When the unit
is powered on again, all calls that are in progress are dropped and the unit will not pass any calls
through until it has started up again.

Locating the Call Recording Unit and PC.

The call recording unit can be rack mounted, free standing or mounted in a CD ROM bay of a PC.
Please note if the recording unit is mounted in a CD ROM bay of a PC, it will have to be powered by a
4 pin power connector from the PC's power supply. With this in mind should the PC ever lose power
or be rebooted, it will drop any calls in progress connected through the unit. The patch lead
connecting the call recorder to the NTE and then the patch lead connecting the call recorder to the
ISDN card in the PBX should be not longer to 5 metres each in length.
The USB lead supplied with the call recording unit is 2 metres in length. This will mean the
call recording until and PC will have to be situated near each other.

Installing the call recording software

Begin the installation by double clicking the install icon.