Configuring The Isdn Card In The Pbx; Connecting The Call Recorder - NEC Univerge SV8100 Installation Manual

Configuring the ISDN card in the PBX

Primary Rate ISDN
If you are using PRI, the card must be set to have CRC4 ON, you set the configuration in Wizards /
Quick Install / Cards / PRI Setup. The card must also be set to trunk mode, refer to the hardware
manual for further information.
Basic Rate ISDN
The card must be set to trunk mode, refer to the hardware manual for further information

Connecting The Call Recorder.

Securely connect the supplied power adapter to the call recording unit. A straight through patch cable
should be connected from the NTE to the 'BRI IN' or 'PRI IN' socket on the front of the recording unit.
Another straight through patch cable should be connected from the BRI or PRI out connector on the
front of the recording unit.
Print Server
Power/TX Link/Rx LPT1 LPT2 COM