NEC Univerge SV8100 Installation Manual page 9

In Wizards / Additional Devices / SMDR / Setup, select SMDR Output Options and configure as
shown below, again click Apply to save the changes. Items that are marked with an X are enabled,
and unchecked items are disabled.
Toll Restriction Calls =
PBX Calls =
Trunk Number / Name = Number
Daily Summary = unchecked
Weekly Summary=unchecked
Monthly Summary =unehecked
Toll Charge Cost = See Below*
Incoming Call =
Extension Number / Name = Number
All Lines Busy (ALB) = unchecked
Walking Toll Restriction Table Number =
DDI Table Name = unchecked
Caller ID Output DDI to Trunk = unchecked
Date = unchecked
Caller ID / DDI Number = Caller ID Number
Trunk / Received Dialed Number = Both
Account Code / Caller ID Name = Account Code
*If your carrier supports Advice of Charge, then you can enable this option and the cost associated
with the SMDR will override any MyCalls costing tables. It's also necessary to setup the appropriate
multiplier for the Toll Charge.
In Wizards / Additional Devices / SMDR / Setup, select SMDR Output for Extensions. Enable each
extension for SMDR output and click Apply to save the changes.