Licensing; Reading The License From The Sv8100 - NEC Univerge SV8100 Installation Manual

Licensing

The MyCalls license is stored in the SV8100 and after MyCalls is installed you have to instruct
MyCalls to read the license from the SV8100 inbuilt license server. After the license has been read
from the SV8100, it will hold its own copy of the license. Only when the license changes on the
SV8100 would you need to reread the license from the SV8100. When the license is working within
MyCalls, it is necessary to register the MyCalls software there is a 15 grace period to register the
MyCalls software. The time it takes to read a license from the SV8100 can vary based on the license
type.
Note: MyCalls will not be able to read a license while the 60 day trial is running on the SV8100.
Before reading the license from the SV8100, you should check that PRG 90-55-01 is set to 0. A
license will also need to be installed on the SV8100.

Reading the license from the SV8100

From the Start / Programs / NEC Infrontia / MyCalls menu, start the License Manager application.
Select SV8100 / Read License from Switch.
Enter the IP Address of the PBX and click read license. The TCP Port can be changed if required,
you would only change the TCP Port if PRG command 10-47 had been changed.
You will be warned that the operation may take some time, click yes to continue.