Sharp MX-C312 Operation Manual page 768

Problem
Colours are off.
Text and lines are faint
and difficult to see.
Part of the image is
cut off.
The image is upside
down.
Point to check
Did you perform "Registration
Adjustment"?
Was colour data printed in black and
white?
(Windows)
Does the paper size specified by the job
match the size of paper loaded in the
tray?
Is the print orientation setting (portrait or
landscape) correct?
Are the margins set correctly in the
layout settings of the application?
Are you using a type of paper (punch
paper, etc.) that can only be loaded in a
fixed orientation?
Ask your administrator to perform "Registration
Adjustment".
If the colours are out of position in the printed output of a
colour print job, "Registration Adjustment" can be used
to adjust the print position of each colour.
➞ System Settings (Administrator) > "Device Control" >
"Other Settings" > "Registration Adjustment"
If the colour tones are off, perform "Auto Colour
Calibration". (If the colours are still off after calibration,
repeating calibration may improve the results.)
➞ System Settings (Administrator) > "Printer Settings" >
"Auto Colour Calibration"
When colour text and lines are printed in black and
white, they may become faint and difficult to see. To
have colour text or lines (areas) that are faint converted
to black, select [Text To Black] or [Vector To Black] on
the [Color] tab of the printer driver. (Raster data such as
bitmap images cannot be adjusted.)
Make sure that the paper size setting matches the size
of paper loaded in the tray.
The paper size setting is selected as follows:
Windows:
On the [Paper] tab of the printer driver.
If [Fit to Paper Size] is selected, check the loaded
paper and the paper size setting.
Macintosh:
In the [Page Setup] menu.
Set the print orientation to match the image.
The print orientation is selected as follows:
Windows: On the [Main] tab of the printer driver.
Macintosh: In the [Page Setup] menu.
If the edge of the image extends outside the printable
area of the machine, the edge will be cut off. Select an
appropriate paper size and margins in the layout
settings of the application.
When the image size and paper size are the same but
the orientations are different, the orientation of the
image is automatically rotated to match the paper.
However, when the paper can only be loaded in a fixed
orientation, this may result in the image being printed
upside down. In this event, rotate the image 180
degrees before printing.
The 180 degree rotation setting is selected as follows:
Windows:
On the [Main] tab of the printer driver.
Macintosh:
On the [Page Setup] menu. (Landscape orientation
only.)
8-25
TROUBLESHOOTING
Solution
Contents