Checking Copies Before Printing (Proof Copy) - Sharp MX-C312 Operation Manual

CHECKING COPIES BEFORE PRINTING
(Proof Copy)
This feature prints only one set of copies, regardless of how many sets have been specified. After the first set is checked
for errors, the remaining sets can be printed. Previously it was necessary to re-scan the original each time changes to
settings were required. However, this feature makes it possible to change settings for the scanned original without
scanning it again, allowing you perform copying more efficiently.
"Proof Copy" is
selected and 5 sets of
copies are executed
Place the original.
Place the original face up in the document feeder tray, or face down on the document glass.
1
After placing the original, specify the original size.
☞
ORIGINAL SIZES
Select copy settings in the base screen.
2
(3)
Special Modes
Proof Copy
3
Bus. Card Scan
1 set of copies is
printed for you to
check
Adjust the
settings
(page 2-29)
(2) (4)
OK
Mixed Size
Slow Scan
Original
Mode
2
2
The remaining 4
sets are printed
If OK
If OK
After adjustments are
made, 1 set is printed
for you to check
Select Proof Copy.
(1) Touch the [Special Modes] key.
☞
SPECIAL MODES
(2) Touch the
screens.
(3) Touch the [Proof Copy] key so that it is
highlighted.
(4) Touch the [OK] key.
2-91
COPIER
The remaining 4 sets
are printed
(page 2-40)
keys to switch through the
Contents