Transmitting An Image; Sending An Image In Scan Mode - Sharp MX-C312 Operation Manual

TRANSMITTING AN IMAGE

SENDING AN IMAGE IN SCAN MODE

This section explains the basic procedure for transmission in scan mode (Scan to E-mail, Scan to FTP, Scan to
Desktop, and Scan to Network Folder).
When a default address is configured in "Default Address Setting" in the system settings (administrator), the mode cannot be
changed, the destination cannot be changed, and destinations cannot be added. If you wish to change the mode or
destination, touch the [Cancel] key in the touch panel and then follow the procedure below.
• When placing the originals, orient them as shown below.
Originals
Portrait orientation*
1
1
Landscape orientation
1
* To place a large portrait-oriented original, place it as shown above in "Landscape orientation" and specify the
placement orientation in step 3.
• Originals cannot be scanned in succession from both the automatic document feeder and the document glass and
sent in a single transmission.
Place the original.
Document feeder tray
Place the original face up.
1
5-25
SCANNER/INTERNET FAX
Document glass
Place the original face down with the middle
aligned with the tip of the
the scale on the left side of the document glass.
1
mark at the middle of
Contents