Adjusting Red/Green/Blue In Copies (Rgb Adjust) - Sharp MX-C312 Operation Manual

ADJUSTING RED/GREEN/BLUE IN COPIES (RGB Adjust)

This feature is used to strengthen or weaken any one of the three colour components R (red), G (green), or B (blue).
Place the original.
Place the original face up in the document feeder tray, or face down on the document glass.
1
After placing the original, specify the original size.
☞
ORIGINAL SIZES
Select the special modes.
(1) Touch the [Special Modes] key.
2
(2) Touch the [Colour Adjustments] key.
(3) Touch the [RGB Adjust] key.
☞
[Colour Adjustments] KEY
(2)
Colour Adjustments
RGB Adjust
Only one colour can be adjusted.
R(Red)
3
-2
Press the [COLOUR START] key.
Copying will begin.
If you are using the document glass to copy multiple original pages, copying will take place as you scan each original. If you
have selected sort mode, change originals and press the [COLOUR START] key. Repeat until all pages have been scanned
4
and then touch the [Read-End] key.
To cancel scanning and copying...
Press the [STOP] key (
To cancel an RGB adjust setting...
Touch the [Cancel] key in the screen of step 3.
R(Red)+
(page 2-29)
(page 2-82)
(1) (3)
OK
Cancel OK
G(Green) B(Blue)
-1 0 1 2
).
G(Green)+
B(Blue)+
Adjust red, green, or blue.
(1) Touch the key of the colour that you wish to
adjust: [R (Red)], [G (Green)], or [B (Blue)].
Only one colour can be adjusted. (If you adjust one colour
and then adjust another colour, the adjustment of the first
colour is cancelled.)
(2) Adjust the selected colour.
Touch the [+] key to strengthen the selected colour, or
touch the [-] key to weaken the colour.
(3) Touch the [OK] key.
You will return to the special modes screen. Touch the
[OK] key to return to the base screen of copy mode.
2-83
COPIER
Contents