FP centormail Operator's Manual page 181

Insert housing connector
Coupling feeder – sealer – dynamic scale – postage meter
Housing connector
Appendix – Moving the centormail mailing system to another location
Housing connector
Postage meter
• Place the centormail and its optional
components on a firm, level, low vibra-
tion horizontal base.
Please refer to page 193 for the standing
surface values of the system in different
configurations.
The components of the mailing system
are mechanically coupled and thus fix-
ated with regard to their position in rela-
tion to one another by means of housing
connectors.
• Slightly lift the postage meter on its
right side and slide the connector into
the clearance of the housing.
On the dynamic scale, sealer and feeder:
• Insert the connectors in the same way
into the right side wall.
• Slightly lift the sealer on its left side,
move it close to the feeder and position
it on the connector.
• Slightly lift the dynamic scale on its left
side, move it close to the sealer and
position it on the connector.
• Slightly lift the postage meter on its left
side, move it close to the dynamic
scale, and position it on the connector.
If your mailing system does not comprise
all components mentioned, couple those
you use in the described way.
181