Sealing Function (Centormail With Sealer) - FP centormail Operator's Manual

16
centormail Operator Manual
3.5 Sealing function
When equipped with the optional components sealer and power sealer, centormail
can meter and seal your mail in a single run. Coming from the feeder, the mail pieces
pass through the sealer. In the sealer, the sealing flap of the envelope is moistened
by a sponge. The flap is then closed and sealed as it passes through the system.
After metering, the mail piece is ultimately closed by the power sealer.
You can use the sealing function for letters with a thickness of up to 0.28" (7 mm).
The envelopes must be suitable for machine sealing (see page 197). Also, please
mind envelope quality. To always achieve optimal sealing results, it is recommended
that sealit™ sealing liquid is used. This is available directly from FP Mailing Solutions
or authorized FP dealer.
(centormail with sealer)
Sealing
If the letters are to be sealed:
• Turn the envelope sealing switch to the
position
centormail monitors the level in the
sealant tank. You are notified when you
have to top up the sealing liquid.
Please reference Chapter 15.8, page 145
for information on how to fill the tank.
If you have not used the sealing function
or if the mailing system was switched off
for a certain amount of time, sealing liquid
is automatically pumped into the moist-
ener. Thus, centormail makes sure the
sponge is properly wetted. In the S
menu, you can set the optimal moistening
level for the envelopes you use (see
Chapter 14.21, page 120).
No sealing
If the letters are not to be sealed (or if they
are already sealed):
• Turn the envelope sealing switch to the
position
SEAL.
NON SEAL.
EALING