Insufficient Memory To Support Resource Save Feature - Lexmark 6500e User Manual

Troubleshooting
30.xx Invalid refill, change cartridge
Remove the print cartridge, and then install a supported one.
Note: The message disappears when a new cartridge is installed.
31.xx Replace defective cartridge
Remove the defective print cartridge, and then install a new one.
32.xx Cartridge part number unsupported by device
Remove the print cartridge, and then install a supported one.
Note: It may take the printer 10–20 seconds to determine whether or not the print cartridge is supported. The
printer may be allowed to print pages during this interval. If pages are allowed to print, then they will not be
reprinted once a valid print cartridge is inserted.
34 Incorrect paper size, open [paper source]
Try one or more of the following:
•
Load the appropriate paper in the tray.
•
From the scanner control panel, touch Continue to clear the message and print the job using a different paper tray.
• Check tray length and width guides and make sure the paper is properly loaded in the tray.
• For Windows users, check the Print Properties settings to make sure the print job is requesting the correct paper
size and type.
For Macintosh users, check the Print dialog settings to make sure the print job is requesting the correct paper size
and type.
• Check that the paper size is correctly set. For example, if the MP Feeder Size is set to Universal, then make sure the
paper is large enough for the data being printed.
•
Cancel the current print job.

35 Insufficient memory to support Resource Save feature

Try one or more of the following:
•
Touch Continue to disable Resource Save and continue printing.
•
To enable Resource Save after receiving this message, make sure the link buffers are set to Auto, and then exit the
menus to activate the link buffer changes. When Ready appears, enable Resource Save.
• Install additional memory.
37 Insufficient memory, some held jobs will not be restored
The printer was unable to restore some or all of the confidential or held jobs on the printer hard disk.
Touch Continue to clear the message.
255