Table of Contents
Advertisement
3Com Router Module Guide
Figure 1-3 Installing MIM (1)
Figure 1-4 Installing MIM (2)
III. Removing MIM
Follow these steps to remove a MIM:
Step 1: Place the rear panel of the Router towards you;
Step 2: Turn off the power switch of the Router and unplug the power cord;
Step 3: Unplug all interface cables from the rear panel of the Router;
Step 4: Loosen the captive screws at both sides of the MIM;
Step 5: Pull the MIM towards you until it is completely separated from the bottom of the
router.
1.6 Troubleshooting
3Com 5000 Routers LEDs, indicate the state of the module as follows:
After the installation of a SIC/MIM, turn on the power and view the corresponding
LEDs (such as SLOT0, SLOT1 or SLOT2) on the cover of the Router chassis: ON
means that the SIC/MIM is operating normally and OFF means that the Power-On
Self-Test (POST) of the SIC/MIM has failed.
1-6
Chapter 1 Overview
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the 3C13886 - Router OC-3 ATM SML Flexible Interface Card and is the answer not in the manual?
Questions and answers