Warning Messages; Selecting Screen Objects; Examples Of Selected Screen Objects - FLIR ThermaCAM E4 Operator's Manual

9.3 – Selecting screen objects
9.2.2

Warning messages

Warning messages are displayed in the center of the screen. Here you will find impor-
tant information about battery status, for example.
Figure 9.3 Critical camera information – a few examples
Message
Battery low
Shutting down
Shutting down in 2 seconds
9.3

Selecting screen objects

9.3.1 Selecting screen objects
Some screen objects – e.g. the scale, the information field, a spot etc. – can be selected
by pressing SEL repeatedly until the object is either highlighted or surrounded by
small brackets. After three seconds the cursor will automatically be hidden. Pressing
SEL or the navigation pad will display the cursor again.
When an object is selected you can use the navigation pad to change its value or,
where applicable, change its position.
9.3.2

Examples of selected screen objects

10383303;4
Figure 9.4 A selected measurement marker (spot). Press the navigation pad at this stage to move the
spot.
30
Explanation
The battery level is below a critical level.
The camera will be switched off immediately.
The camera will be switched off in 2 seconds.
Publ. No. 1 558 017 Rev. a62 – ENGLISH (EN) – August 19, 2004