7.3 – Working with measurements
Step
3
7.2.3
Saving an image
Step
1
2
3
4
7.2.4
Opening an image
Step
1
2
3
7.3
Working with measurements
7.3.1
Laying out a spot
➲ The camera requires a warm-up time of 5 minutes before accurate measurements
can be expected.
Step
1
2
12
Action
Briefly pressing SAVE/FRZ will display a confirmation box.
To save the image, press YES
■
To leave the confirmation box without saving the image, press NO
■
Action
Adjust the focus by turning the focus ring at the front of the lens.
➲ Please note what is the locking ring and what is the focus ring in the figure on
page 20. Trying to adjust the focus by rotating the locking ring will remove the
lens.
If the camera is in manual adjust mode, press and hold down SEL for more than
one second to autoadjust the camera.
Briefly press SAVE/FRZ to freeze the image. This will display a confirmation box
where you will be prompted to accept or cancel the image. Accepting the image
will save it to the internal memory.
To save an image directly (without freezing the image first), press SAVE/FRZ for
more than 1 second.
Action
Press MENU/YES to display the vertical menu bar.
Point to File on the vertical menu bar and press the MENU/YES.
Point to Images to display thumbnails of the most recently saved images.
To open an image, select the image by pressing the navigation pad left/right or
up/down and then press MENU/YES.
Action
Press MENU/YES to display the vertical menu bar.
Point to Meas. mode on the vertical menu bar and press MENU/YES.
Publ. No. 1 558 017 Rev. a62 – ENGLISH (EN) – August 19, 2004