Button
Trigger
8.3
Laser LocatIR
By pulling the trigger on the bottom side of the camera body, a laser dot appears
approx. 40 mm/1.57" above the target.
➲ Please note the following:
A laser icon appears on the screen when the Laser LocatIR is switched on.
■
Since the distance between the laser beam and the image center will vary by the
■
target distance, Laser LocatIR should only be used as an aiming aid. Always check
the LCD to make sure the camera captures the desired target.
Do not look directly into the laser beam.
■
When not in use, the Laser LocatIR should always be protected by the lens cap.
■
For more information about trigger settings, see section 9.4.9.1 – Settings on page
38.
10376403;2
Figure 8.4 Wavelength: 635 nm. Max. output power: 1 mW. This product complies with 21 CFR 1040.10
and 1040.11 except for deviations pursuant to Laser Notice No. 50, dated July 26th, 2001
Publ. No. 1 558 017 Rev. a62 – ENGLISH (EN) – August 19, 2004
Comments
Pull the trigger to do one of the following:
Save the image
■
Switch on or switch off the Laser LocatIR
■
Autoadjust the camera
■
Update ref. temp
■
The function of the trigger depends on the trigger settings in the
Settings dialog box. For more information about trigger settings,
see section 9.4.9.1 – Settings on page 38
8.3 – Laser LocatIR
27