Camera Program; Result Table; System Messages; Status Messages - FLIR ThermaCAM E4 Operator's Manual

9

Camera program

9.1

Result table

The results of measurement markers are displayed in a result table in the top right-
hand corner of the screen.
Figure 9.1 Explanation of measurement markers appearing in the result table
Icon
Max
Min
1
1
9.2

System messages

9.2.1

Status messages

Status messages are displayed at the bottom of the screen, or in the top left part of
the screen. Here you will find information about the current status of the camera.
Figure 9.2 Status messages – a few examples
Message
Frozen
Manual
Please wait
Restarting
Saving as
Publ. No. 1 558 017 Rev. a62 – ENGLISH (EN) – August 19, 2004
Explanation
Spot
Area, maximum temperature
Area, minimum temperature
Area, average temperature
Color alarm above
Color alarm below
Difference between spot 1 and spot 2
Explanation
Message is displayed when the image is frozen.
Message is displayed when the camera is currently in manual adjust
mode.
Message is displayed during operations that take some time.
Message is displayed when the software is restarted, i.e. after Factory
default.
Message is displayed while an image is being saved.
29