Pump Removal - Henny Penny 500 Technical Manual

2-15. FILTERING SYSTEM
(Continued)
2-50

Pump Removal

1. If the pump needs to be replaced, loosen one inch nuts
from the outfl ow and infl ow lines. Then remove the two
bolts holding the pump to the motor with a 1/2 inch wrench.
2. The shaft seal should remain on motor shaft, or if leaking,
could be replaced at this time.
Step 1
3. To replace the pump, remove the four Allen screws, front
plate, rotor, and rollers from pump. Place the pump onto
shaft and against the shaft seal. Place the two 1/2 inch bolts
through the pump and into the motor and tighten. Then
replace rotor, rollers, front plate and tighten Allen screws.
Step 2
When removing a pump from a motor, note the positions of
the inlet and outlet parts. Installation of the pump on the
motor in any other position could cause damage to the fryer.
There is an indicator on the side of the two halves of the
pump, this mark must be together and face to the front of the
fryer.
Model 500/600
305