Henny Penny 500 Technical Manual page 35

1-5. DIAGNOSTIC MODE
DETAILS (Continued)
305
If any of the product settings do not match original values, the
following message is displayed (with one or more of the product
numbers blinking):
"10: PROD'S 123456"
"10: DO NOT MATCH"
"10: ORIG. VALUES"
In this case, the blinking numbers indicate which products do
not match original settings. If the numbers 3 and 5 are the only
numbers blinking, then product #3 and product #5 each have
at least one setting changed from their factory preset values.
Products 1, 2, 4, and 6 are confi rmed to exactly match their original
settings.
The second item in D 10 identifi es how many items in CFA
Programming Mode have been changed from their original values.
These Chick-fi l-A settings mainly deal with special Chick-fi l-A
controller features like oil wear, heat-up monitoring, new oil
compensation, oil idle compensation, drop detection, amps and
voltage alarms, and Clean-out Mode.
If all items in CFA Prog Mode match their original, factory preset
values, the following report is made:
"10: ALL CFA ITEMS"
"10: MATCH"
"10: ORIG. VALUES"
If any of the items in CFA Prog Mode do not match their original
values, the following message is displayed (with the actual number
of changed items):
"10: 2 CFA ITEMS"
"10: DO NOT MATCH"
"10: ORIG. VALUES'
A similar report is made for Special Program Mode. Special
Program (SP) Mode settings deal with °F/°C display, speaker tone
and volume, Melt and Idle Modes, and how the product buttons
function (start cook or merely select product).
"10: ALL SP ITEMS"
"10: MATCH
"10: ORIG. VALUES "
"10: 1 SP ITEMS "
" "10: DO NOT MATCH "
"10: ORIG. VALUES "
Model 500/600
1-31