2-14. PRESSURE
REGULATION/
EXHAUST (Continued)
305
Reversing the Lid Gasket
(Continued)
1. There are two lid liner screws on either side of the lid cover.
Back these four screws out about 1/2 inch.
Step 1
2. Open lid and, using a thin blade screwdriver, pry out the
gasket at the corners. Remove the gasket.
3. Clean the gasket and gasket seat with hot water and cleaning
detergent. Rinse with clean hot water.
4. Install the gasket with the good side facing out. Tighten the
four screws.
Step 2
Model 500/600
2-41