Henny Penny 500 Technical Manual page 55

2-8. HEATING ELEMENTS
(ELECTRIC MODELS)
305
Description
Each electric fryer uses three heating element assemblies.
Heating elements are available for 208, 220/240, or 440/480
voltage. Check the data plate inside the door to determine the
correct voltage.
Maintenance Hint
If the shortening's temperature recovery is very slow, or at a
slower rate than required, this may indicate defective heating
element(s). An ohmmeter will quickly indicate if the elements are
shorted or open.
Checkout
1. Remove electrical power supplied to the fryer.
To avoid electrical shock or property damage, move
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove the control panel and insert it in the slot
above the door. Refer to paragraph 2-4.
3. Perform an ohm check on one heating element at a
time, with wires disconnected from element. If the
resistance is not within tolerance, replace the element.
HEATER
P/N POWER
18233-1 4500W
18233-2 4500W
18233-4 3750W
18233-5 3750W
18233-6 3750W
18233-7 4500W
18233-8 4500W
RESISTANCE IN
VOLTAGE OHMS (COLD)
208VAC 9+1
230VAC 11+1.5
208VAC 11+1.5
220VAC 12+2
480VAC 60+5
480VAC 50+4
380VAC 32+3.5
Model 500/600
2-9